Description

Over the years we have had numerous requests to make a small, fully cased, assembled Speeduino compatible ECU for basic bike and car installs.
Several iterations later, we have created the C2C, the Compact 2 Channel.
It has enough outputs to run fuel and ignition on engines with up to 4 cylinders.
It also has all the other standard inputs and outputs you’d expect, the full spec is below.
The case is a compact 84 x 58 x 25 mm, roughly the size of a pack of cards.

The design has the main Arduino chip onboard, so there’s no need for a separate Arduino Mega, which is what let us make it so small.
There’s an internal MAP sensor and space for a VR conditioner should your trigger setup require one.
Engine connection is via a 24 pin Microfit Molex connector.
Our Bluetooth module is also plug and play via the 4 pin Microfit Molex connector.

The board is pin-for-pin compatible with the NO2C board, meaning you can swap between them with no change in loom or connector.
The board type in Tunerstudio should also be set to “NO2C”

A short (30CM) pigtail loom for this connector can also be added to your order to make splicing into an existing loom easier.

Full Specification

On-board USB
Internal MAP Sensor (4 Bar)
Connector for optional Bluetooth module

Outputs:

• • • 2 ignition channels (Low/Logic level)
    • 2 injector channels
    • 4 Low side outputs
      • Idle
      • Boost
      • VVT
      • Fuel pump
    • Tachometer
    • 5v Sensor supply

Inputs:

• • • Throttle position sensor (TPS)
    • Coolant temperature sensor (CLT)
    • Air temperature sensor (IAT)
    • O2 sensor (narrowband or wideband)
    • Launch control (Clutch switch)
    • Hall Effect Crank/Cam (VR with optional daughter-board and module)